| |
Resilient Synthetic Floor Finish
Global VCT-22™ is a revolutionary new product that will change the way you think about VCT floors and budgeting to maintain them. This easy
to use, wear resistant terpolymer based floor finish levels beautifully providing
exceptional durability, protection and adhesion properties. With Excellent chemical resistance, VCT-22™ repels stains
that would otherwise mar unprotected floors and protects against, iodine, betadine, mustard,
coffee, wine, rust, and other dyed products. Tested to be 66% more slip resistant than industry requirements.
- Uses
- Features & Benefits
- DIRECTIONS FOR USE
- PERFORMANCE DATA:
| USES: For long-life, low maintenance use on resilient tile floors in: |
• Hospitals
• Factories
• Department Stores
• Hotels |
• Nursing Homes
• Schools
• Government Facilities
• Office Buildings |
• Grocery Stores
• Universities
• Airports
• Warehouses |
| FEATURES & BENEFITS: |
- Exceptional durability
- Stain resistant
- Scuff resistant
- Optical brighteners
- Superior color
- Tested to be 66% more slip resistant than industry requirements
- Superior adhesion
- Non DOT regulated
- Repairs easily
- 5 Year Warranty
|
|
DIRECTIONS FOR USE:
Initial Application:
|
- Before applying the VCT-22™ Finish, make sure that the floor surface is properly prepared. When the floor has been stripped, all prior sealers, wax, stains and residual stripper should be removed and the pH of the floor should be returned to neutral (6.5 - 7.5). Hand clean any and all areas that still have residue from prior finishes and along base boards and in corners where the machine scrubbers cannot reach.
- After floor is completely dry apply the VCT-22™ Finish in thin coats using a clean micro-fiber mop. In addition to vertical strokes it is advisable to use a figure 8 pattern to ensure that all areas are thoroughly covered.
- Allow VCT-22™ Finish to dry sufficiently before applying additional coats (approximately 30 minutes in normal ventilated areas).
- Four coats of the VCT-22™ Finish are recommended. Repeat steps 2 & 3 for each coat.
Daily Maintenance
Continue normal maintenance as you would for waxed floors. It is recommended that you dust and mop on a daily basis. Spray and buff with VCT-22™ Spray & Buff on normal cycle or as desired to restore luster of original application.
Damaged floors
If the VCT-22™ Finish is cut or scratched by a sharp object this area can be repaired most times by simply reapplying additional coats of VCT-22™ Finish that will level to the original application. If by chance the area of damage needs to be stripped, Global Surface Solutions can provide stripper that will unlock the formula to prep the area for additional VCT-22™ Finish to be applied.
|
| PERFORMANCE DATA: |
| Approximate Coverage: |
1100-1500 sq. ft./gal |
| Adhesion: |
Excellent |
| Finish Compatibility: |
Excellent |
| Water Resistance: |
Excellent |
| Detergent Resistance: |
Yes, can only be removed with special strippers. |
| Application: |
Resilient Tile Floors, Quarry Tile Floors, Terrazzo Floors,
Sealed Wood Floors and Concrete Floors. |
|
|
REMARKS: A new breed of semi-permanent floor finish formulated specifically for use on resilient tile floors where high-performance and low-maintenance are desired. Engineered for safety...this finish utilizes special slip resistant additives. Exceeds industry standards for static coefficient of friction (ASTM2047/82). |
